Warmlite WL44002 - Operation of Your Heater; Auto Safety Shut Off

Product Helpline. 0871 221 3618 For all your product needs.
OPERATION OF YOUR HEATER
Remove the heater from all packaging and place it in desired location.
Ensure that there is a safe area between the heater and furniture, curtains, etc-50cm
safe area form top and sides and 120cm safe area in front.
Unwind the Power Cord and plug it into the Power Outlet.
To activate the heater, turn the knob clock-wise to the ‘* ’position for cool air. Turn the
knob to ‘I’ for low power, ’II’ for maximum power.
AUTO SATETY SHUT OFF
e heater has a built-in safety device, which will switch the heater OFF in case of ac-
cidental overheating. To reset the heater, follow the next steps:
•Turn the control setting to the ‘O’ position.
•Unplug the heater and wait 5-10minutes for the unit to cool down.
•Aer the unit has cooled, plug it in and operate normally.
•Turn selector switch into desired position (Fan, Low or High).
•Turn the thermostat switch to the desired temperature position.
•When you feel the room temperature comfortable, turn the thermostat switch anti-
clockwise slowly to the minimal direction until the appliance switches o.
•e thermostat switch will keep the room temperature at the desired temperature
automatically.
•You can also turn the thermostat switch anti-clockwise to the minimum position or
turn the thermostat switch clockwise to the maximum position to make the tempera-
ture lower or higher.
Note: NEVER COVER THE HEATER
DO NOT IMMERSE IN WATER OR ANY LIQUID
Be sure to switch o the power supply and pull out the plug out the plug before clean-
ing.
Wait for the heater to cool down suciently.
Clean the body of the heater with a damp cloth. DO NOT ALLOW water into the ap-
pliance.
DO NOT use soap or chemicals which may damage the housing of the heater.
Allow sucient drying time before operating again.
Clean the air inlets and outlets regularly with a vacuum cleaner
(with regular use, at least twice a year)
When the unit is not in use, we recommend that the heater is re-packed in its origi-
nal packaging and stored in a cool, dry place.
Model no: Serial no: Batch no: Name: Address: Date Purchased: E-mail Address: IMPORTANT is warranty is invalid if alterations have been made to this certicate
Dealer Stamp/Details:
If you would NOT like to receive special oers and promotions from PFD and it’s associated companies please tick this box