WARRIOR 56192 - Page 9

Page 9;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 56192
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
O.,83"83%S7,9*
%
GI%JK6!6MG%LM_PKH-%%U"#4.,(3*%S,$$*(V%
4&5/7*$*7V%+*2&(*%4.,83"83%S7,9*1%Q*,(%
.*,WV?9'$V%)&(X%37&W*#%)."7*%4.,83"83%S7,9*1
1. With a screwdriver, align Spindle Lock (inside)
with slot (outside) on right side of tool.
E/"897*%
T&4X
`"8#"9*a
#7&$%
`&'$#"9*a
2. While holding Spindle Lock with screwdriver,
Remove Blade Screw with another screwdriver.
S7,9*%
E4(*)
3. Remove Blade and replace with same
type Blade (not included).
4. Tighten Blade Screw securely.
S,$$*(V%K*5&W,7
MIG6- Contains Li-Ion battery. Battery must
be recycled or disposed of properly. Do not
open, crush, heat above 140°F or incinerate.%
1. Remove all nine screws from back,
then remove back cover.
E4(*)#
E4(*)#
2. Disconnect wires and remove Battery.
S,$$*(V