Watchman FD-30A - Dial Cord Stringing Procedure; Dial Cord Preparation and Stringing; Dial Pointer Setting

D BOARD AND PICTURE TUBE
5] Release the claw.
G BOARD
NOTE ON ASSEMBLING
When reinstalling the control indication
plate, position as illustrated.
Turn the control knob
MAX position.
FD-30A
FD-30A
4 } CRT support
@ Pull out the D board.
© Pull out the picture
tube socket.
control knob
control indication plate
Oru out the control
indication plate.
1-2. DIAL CORD STRINGING
1) Dial Cord Preparation
2) Dial Cord Stringing
dial drum
3) Pointer Setting
After the stringing; turn the tuning knob fully
clockwise.
dial pointer
tuning knob
After setting dial pointer, apply a
locking compound.
Set the center of the dial pointer
at this left side of rib.
20
15
10
O (cm)
O (inch)