CLS200 Series User’s Guide
Chapter 6: Ramp/Soak
126
This is the single loop display when a profile is running. If a tolerance alarm occurs, the controller
displays a flashing T in the alarm symbol position.
ALARM
02 347 ˚F
T 180TOHO50
Loop Number
Alarm Symbol
Engineering Units
Setpoint
Ramp/Soak Mode
Output Percentage
Process Variable
Bar Graph Display
The ramp/soak mode is also displayed on the bar graph display. Table 6.5 describes the control
status symbols used for loops with ramp/soak profiles assigned.
ALARM
01> > < < 08
RSHS ROMA
Symbol
Loop Number
Ramp/Soak Mode
Table 6.5 — Ramp/Soak Control Status Symbols
RAMP/SOAK SYMBOL DESCRIPTION
R
A profile is running
H
A profile is holding.
S
A profile is in ready state/start mode.
O
A profile is in tolerance hold.
W
A profile is in trigger wait.
Time Remaining Display
From the single loop display, press the RAMP/SOAK key once.
This screen shows how much time remains to complete the profile. All screens that are accessed by
pressing RAMP/SOAK key have the same information on the top line.
ALARM
04 A SEG10/20 R
TIM REM= 32:11
Loop Number
Profile Letter
Current Segment
Number of Segments
Ramp/Soak Mode
in Profile
Time Remaining
To Next Page
Loading...
