Watlow ez-zone pm - Page 39

Watlow EZ-ZONE
®
PM Integrated Controller • 36 • Chapter 4 Home Page
Possible
Home Page Defaults
(Dependent on Part Number)
Home Page
Display
Parameter Page and Menu
All Models
1 Active Process Value (1)
Numerical
value
Operations Page, Monitor Menu
2 Active Set Point (1)
Numerical
value
Operations Page, Monitor Menu
IF 9th digit of PN is equal to:
PM _ _ _ _ _ - _ _ [L, M] _ _ _ _
3 Process Value (2)
Numerical
value
Operations Page, Monitor Menu
4 Limit Status
[safe]
or
[fail]
Home Page
IF 9th digit of PN is equal to:
PM _ _ _ _ _ - _ _ [A, C, J, R, P, T] _ _ _ _
3 Active Process Value (2)
[pu;a2]
Operations Page, Monitor Menu
4 Closed Loop Set Point (2)
[C;sp2]
Operations Page, Monitor Menu
5 User Control Mode (1)
[C;M1]
Operations Page, Monitor Menu
6 Heat Power (1)
[h;pr1]
Operations Page, Monitor Menu
7 Cool Power (1)
[C;pr1]
Operations Page, Monitor Menu
8 Autotune (1)
[aut1]
Operations Page, Loop Menu
9 Idle (1)
[id;s1]
Operations Page, Loop Menu
10 User Control Mode (2)
[C;m2]
Operations Page, Monitor Menu
11 Heat Power (2)
[h;pr2]
Operations Page, Monitor Menu
12 Cool Power (2)
[C;pr2]
Operations Page, Monitor Menu
13 Autotune (2)
[aut2]
Operations Page, Loop Menu
14 Idle (2)
[id;s2]
Operations Page, Loop Menu
15 Limit Set Point Low
[ll;s1]
Operations Page, Limit Menu
16 Limit Set Point High
[lh;s1]
Operations Page, Limit Menu
17 Start Profile
[p;st1]
18 Action Request
[p;aC1]
19 None
20 None
Note:
Numbers within parenthesis indicates
the instance.