Watlow ez-zone pm - Page 56

Watlow EZ-ZONE
®
PM Integrated Controller • 53 • Chapter 5 Operations Page
Operations Page
Display
Parameter name
Description
Range Default
Parameter
Appears in
Menu When
Modbus Rela-
tive Address
CIP
Class
Instance
Attribute
hex (dec)
Profibus
Index
Data
Type
&
Read/
Write
[`S;ti]
[ S.ti]
Profile Status
*Step Time Remain-
ing
View or change the
time remaining for
the current step.
Step is displayed
in seconds. If the
time exceeds 9,999
seconds, the display
will show 9,999 and
remain there while
the control contin-
ues to decrement
internally. Once the
remaining time is
equal to or less than
9,999 the display
will represent the
actual seconds re-
maining.
As an example, if a
three-hour soak time
is currently being
monitored, the first
value displayed will
be 9,999, and the
display will remain
at 9,999 until the
remaining time is
approximately equal
to 2 hours and 46
minutes. At this
point the display
will track the actual
seconds remaining.
0 to 9,999.000 seconds 0 Always Instance 1
Map 1 Map 2
2536 4356
0x7A (122)
1
9
- - - - float
RW
[Ent1]
[Ent1]
Profile Status
Active Event Out-
put 1
View or change the
event output states.
[`off] Off (62)
[``on] On (63)
Off Always Instance 1
Map 1 Map 2
2546 4366
0x7A (122)
1
0xE (14)
- - - - uint
RW
[Ent2]
[Ent2]
Profile Status
Active Event Out-
put 2
View or change the
event output states.
[`off] Off (62)
[``on] On (63)
Off Always Instance 1
Map 1 Map 2
2548 4368
0x7A (122)
1
0xF (15)
- - - - uint
RW
[``JC]
[ JC]
Profile Status
Jump Count Re-
maining
View the jump counts
remaining for the
current loop. In a
profile with nested
loops, this may not
indicate the actual
jump counts remain-
ing.
0 to 9,999 0 Always Instance 1
Map 1 Map 2
2538 4358
0x7A (122)
1
0xA (10)
- - - - uint
R
Note:
Some values will be rounded off to fit in the four-character display. Full values can be read with
other interfaces.
* Available with PM4, PM8 and PM9 models only
R: Read
W: Write
E: EE-
PROM
S: User
Set