Watlow ez-zone pm - Chapter 6: Setup Page; Setup Page Menu Details

Watlow EZ-ZONE
®
PM Integrated Controller • 93 • Chapter 8 Factory Page
Factory Page
Dis-
play
Parameter name
Description
Range Default
Parameter
Appears in
Menu When
Modbus
Relative Ad-
dress
CIP
Class
Instance
Attribute
hex (dec)
Profibus
Index
Data
Type
&
Read/
Write
[Cust]
[fcty]
Custom Menu
[`par]
[ Par]
Custom Menu
Parameter 1 to 20
Select the param-
eters that will ap-
pear in the Home
Page.
The Parameter 1
value will appear
in the upper dis-
play of the Home
Page. It cannot
be changed with
the Up and Down
Keys in the Home
Page.
The Parameter 2
value will appear
in the lower dis-
play in the Home
Page. It can be
changed with the
Up and Down
Keys, if the pa-
rameter is a writ-
able one.
Scroll through the
other Home Page
parameters with
the Advance Key
‰
.
[nonE] None
[gSd1] Guaranteed Soak
Deviation 1 Value
[gSd2] Guaranteed Soak
Deviation 2 Value
[P;ACr] Profile Action
Request
[P;Str] Profile Start
[idLE] Idle Set Point
[t;tUn] TRU-TUNE+
®
Enable
[`r;rt] Ramp Rate
[`C;hy] Cool Hysteresis
[`C;Pb] Cool Proportion-
al Band
[`h;hy] Heat Hysteresis
[`h;Pb] Heat Propor-
tional Band
[``db] Dead Band
[``td] Time Derivative
[``ti] Time Integral
[`C;Pr] Cool Power
[`h;Pr] Heat Power
[`C;M] User Control
Mode
[`AUt] Autotune
[``op] Open Loop Set
Point
[AC;SP] Active Set Point
[AC;pu] Active Process
Value
[StPt] Set Point
CUSt] Custom Menu
[`A;hy] Alarm Hysteresis
[`A;hi] Alarm High Set
Point
[`A;Lo] Alarm Low Set
Point
[USr;r] User Restore Set
[`C_F] Display Units
[`i;CA] Input Calibration
Offset
[`Pro] Process
[`CU;r] Current Read
[`LL;S] Limit Low Set
Point
[`Lh;S] Limit High Set
Point
[`L;hy] Limit Hysteresis
See:
Home
Page
Always
- - - - - - - - - - - - - - - -
Note:
Some values will be rounded off to fit in the four-character display. Full values can be read with
other interfaces.
If there is only one instance of a menu, no submenus will appear.
R: Read
W: Write
E:
EEPROM
S:
User
Set