Watlow ez-zone pm - Alarms

Watlow EZ-ZONE
®
PMI Controller • 202 • Chapter 9 Features
11. Advance ‰ to Source Instance D and use the up arrow ¿ to make a selection below:
If Source Function A of previous step is set to None nonE:
1 Does not matter which number is here
si.d Source Instance D
If Source Function A of previous step is set to Digital I/O dio:
5 Select 5 to 12
si.d Source Instance D
If Source Function A of previous step is set to Function Key fUn:
1 EZ1 Key
2 EZ2 Key
6 Hold innity key for 2 seconds
7 Innity ˆ and Down arrow ¯
8 Innity ˆ and Up arrow ¿
si.d Source Instance D
12. Advance ‰ to Time Remaining t.r, read only, display in hh:mm or mm:ss.
13. Advance ‰ to Ready Band State r.bs, read only, displayed as yes yEs or no no.
14. Advance ‰ to Ready Band rdy to enter the value for Ready Band using Up ¿ or Down ar-
row ¯.
15. Advance ‰ to Time Format t.for to select the time format. Use the up arrow ¿ to make
selection below:
thЛЏ Time Hours:Minutes
tЛЏs Time Minutes:Seconds
16. Advance ‰ to Countdown Time to enter hours, minutes and seconds using the Up ¿ or
Down arrow ¯.
hoUr Hours, then Advance ‰
ЛЏin Minutes, then Advance ‰
SEC Seconds
17. Advance ‰ to Closed Loop Timer Set Point Ct.SP to enter the temperature during count-
ing using the Up ¿ or Down arrow ¯.
18. Advance ‰ to Signal Time st to enter time in seconds for Timer Event Output 3 tE.o3 to
be active at end of countdown time.
19. Press and hold the Innity ˆ or Reset key for more than 2 seconds to go to Home Page.
20. See programming custom home page in factory page, custom menu to change the display
parameters such as active process value, closed loop set point time, closed loop timer
set point and time remaining as appropriate for the application.
Alarms
Alarms are activated when the output level, process value or temperature leaves a dened
range. A user can congure how and when an alarm is triggered, what action it takes and
whether it turns off automatically when the alarm condition is over. Congure alarm outputs
in the Setup Page before setting alarm set points. Alarms do not have to be assigned to an
output. Alarms can be monitored and controlled through the front panel or by using soft-
ware.