Watlow ez-zone pm - Changing the Set Point; Starting a Profile from the Home Page; Ending a Profile from the Home Page; Modifying the Home Page

Watlow EZ-ZONE
®
PMI Controller • 59 • Chapter 4 Home Page
Changing the Set Point
You can change the set point by using the Up ¿ or Down ¯ keys when a prole is not run-
ning.
Starting a Profile from the Home Page
1. When at the Home Page, press the Advance Key ‰ to locate Prole Start and select the
le or step number to start. The upper display will show 1 and the lower display will show
p.st1.
2. Press the Up ¿ or Down ¯ key to choose the le or step number.
3. Press the Advance Key ‰ to select the Prole Action Request. The upper display will show
nonE and the lower display will show p.aC1.
4. Press the Up ¿ or Down ¯ keys to select the Prole Start. The upper display will show
prof and the lower display will show p.aC1.
5. Press the Innity ˆ Key to return Home. The Prole will Start
Ending a Profile from the Home Page
1. Press the Advance Key ‰ to select the Prole Action Request. The upper display will show
nonE and the lower display will show p.aC1.
2. Press the Up ¿ or Down ¯ keys to select the End. The upper display will show End and
the lower display will show p.aC1.
3. Press the Innity ˆ Key to return Home. The Prole will End.
Modifying the Home Page
1. Push and hold the Advance ‰ key and the Innity ˆ key for approximately six seconds.
Upon entering the Factory Page the rst menu will be the Custom Menu
CUst
.
2. Push the Advance ‰ key where the lower display will show CUst and the upper display
will show 1.
3. Push the Advance ‰ button where the prompt for the Process Value
aC.pu
will be dis-
played on top and Parameter par in the bottom. There are twenty positions available
that can be customized.
4. Pushing the Up ¿ or Down ¯ arrow keys will allow for a customized selection to be
made (see list of available parameters below).
Custom Menu Parameter Options
Description Prompt *
All Models
None Blank
Analog Input Value
ain1 ain2
Cal In Offset
i.Ca1 i.Ca2
Display Units
C_f1
Load Parameter Set
Usr.1 Usr.2
Alarm Low Set Point
a.Lo1 A.Lo2 a.Lo3 A.Lo4
Alarm High Set Point
a.hi1 a.hi2 a.hi3 a.hi4
Alarm Hysteresis
a.hy1 a.hy2 a.hy3 a.hy4