Watlow ez-zone pm - Page 64

Watlow EZ-ZONE
®
PMI Controller • 60 • Chapter 4 Home Page
Custom Menu Parameter Options
Description Prompt *
If 4th digit of part number is T
Time Remaining
t.r
Ready Band State
r.bS
Ready Band
rdy
Closed Loop Timer Set Point
Ct.Sp
Hours
hoUr
Minutes
ЛЏin
Seconds
SEC
If 4th or 9th digit of part number is L or M
Limit Set Point Low
LL.s1
Limit Set Point High
Lh.s1
Limit Hysteresis
L.hy1
Limit Status
L.st1
If 4th digit of part number is B, E, C, R, J, or N
Set Point
C.sp1 C.sp2
Active Process Value
AC.p1 AC.p2
Active Set Point
AC.s1 AC.s2
Manual Power
o.sp1 o.sp2
Autotune
aUt1 aUt2
Control Mode
C.ЛЏ1 C.ЛЏ2
Heat Power
h.pr1 h.pr2
Cool Power
C.pr1 C.pr2
Time Integral
ti1 ti2
Time Derivative
td1 td2
Dead Band
db1 db2
Heat Prop Band
h.pb1 h.pb2
On/Off Heat Hysteresis
h.hy1 h.hy2
Cool Prop Band
C.pb1 C.pb2
On/Off Cool Hysteresis
C.hy1 C.hy2
Ramp Rate
r.rt1 r.rt2
TRU-TUNE+ Enable
t.tU1 t.tU2
Idle Set Point
id.s1 id.s2
If 4th digit of part number is B, E, R or N
Profile Start
p.str
Profile Action Request
p.aCr
Current Step
Stp
Step Type
S.typ