Watlow ez-zone pm - Chapter 6: Setup Page; Setup Page Menu Details

Watlow EZ-ZONE
®
PMI Controller • 92 • Chapter 6 Setup Page
6
Chapter 6: Setup Page
* These parameters/prompts are available with firmware revisions 11.0 and above.
Navigating the Setup Page
To navigate to the Setup Page follow the steps below:
1. From the Home Page, press and hold both the Up ¿ and Down ¯ keys for six seconds. Ai
will appear in the upper display and SEt will appear in the lower display. If the up and down
arrow keys are released where opEr is displayed, simply press and hold those same keys for
an additional 3 seconds.
Note: (for firmware release 13 and below)
If keys are released when opEr is displayed, press the Infinity Key ˆ or reset key to exit
and repeat until SEt is displayed.
2. Press the Up ¿ or Down ¯ key to view available menus.
3. Press the Advance Key ‰ to enter the menu of choice.
4. If a submenu exists (more than one instance), press the Up ¿ or Down ¯ key to select and
then press the Advance Key ‰ to enter.
5. Press the Up ¿ or Down ¯ key to move through available menu prompts.
6. Press the Infinity Key ˆ to move backwards through the levels: parameter to submenu, sub-
menu to menu, menu to Home Page.
7. Press and hold the Infinity Key ˆ for two seconds to return to the Home Page.
On the following pages, top level menus are identified with a yellow background color.
Note:
Some of these menus and parameters may not appear, depending on the controller's op-
tions. See model number information in the Appendix for more information. If there is
only one instance of a menu, no submenus will appear.
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon
controller part number.
Ai
sEt Analog Input Menu
1
Ai Analog Input (1 to 2)
sEn Sensor Type
Lin TC Linearization
rtL RTD Leads
Unit Units
s.Lo Scale Low
s.hi Scale High
r.Lo Range Low
r.hi Range High
P.EE Process Error En-
able
P.EL Process Error Low
Value
t.C Thermistor Curve
r.r Resistance Range
fiL Filter
i.Er Input Error Latching
dEC Display Precision
i.Ca Calibration Offset *
ain Analog Input Value *
i.Er Input Error *
d.bi
SEt Digital Bus Menu
1
d.bi J1939 Instance (1 to 6)
Unit Unit
C.Idh CAN ID High Word
C.IdL CAN ID Low Word