3
A. Outlet LEDs: ese illuminate when power to the matching outlet is on.
e outlets are switchable (IP controlled).
B. Power/Network LED: See page 4.
C. AC Power Button: Press to manually toggle the outlets on or o.
D. Mounting Eyelets.
E. Network Connection: Connect to the Local Area Network (LAN) for IP
setup, control, and monitoring.
F. Power Inlet: Outlet for 3-prong IEC power cord.
G. External Fuse*: May need replacement aer an overload.
H. Mounting Bracket Grooves
I. Reset Button: Use a thin tool (paper clip, toothpick) to press this to restart
the network card (no settings are changed). Press and hold 5 seconds to
set the power strip to DHCP. Press and hold 10 seconds to reset the power
strip to factory default.
J. Internet LED: See page 4.
K. Link/Activity LED: See page 4.
* CAUTION: For inlet fuse rating: T15AH, 125VAC/250VAC or F15AH,
125VAC/250VAC. Failure to replace the fuse with the same size, type, and
ratings will damage the device and the connected and nearby equipment, and
will cause electrical shock, re, explosion, or injury.
To Next Page
Loading...
Need help?
General