WIRELESS Energy Monitor
- Smart Meter
Monitors your electricity use and cost in real time
Energy saving made simple
MONITOR•CONTROL•SAVE
Quick Guide
EW4500
How do I install and set up the wireless energy
monitor correctly?
1. Power Transmitter
Write down the CHANNEL number you selected and the ID number displayed. You will need
this information later to pair the Display Unit with Transmitter during setup.
NOTE: If you are using Tiered-rate, press [ Select
E
] and enter tiered-rate mode
with the procedures shown under “How do I set the tiered-rate?” section in the
user manual.
NOTE
Setup with˅and˅button. Press [ Select
E
] to conrm the value.
A
2. Display Unit
Setting the menu in Display Unit. Press the [ Menu
C
] button for 3 seconds to enter the
Menu setting.
Day Month
Inpulse
Price per
kWh
currency
channel
ID code
AA
Hour Minutes
AA
AA
AA
A
A
A
Year
3. Optical Sensor
Step 1.) Determine the LED port (LED light) of the electricity meter and determine the impluse
rate indicated by imp/kWh or imp/unit.
Step 2.) Use the mounting accessories provided to attach the sensor base hole over the ash-
ing LED found on your electricity meter. Attach it rmly in place.
Made sure the LED diode of your meter is exactly in the middle of the mounting bracket.
LED diode
attach
How do I install and set up the wireless energy
monitor correctly?
Step 3.) After mounting the sensor to your electricity meter, connect the mini jack of the sen-
sor to the Power Transmitter.
IMPORTANT: Avoid direct light to the sensor when it is operating as this may
cause errors in readings.
IMPORTANT: DO NOT connect the LED sensor until the pairing is done and the
LED sensor is attached to the meter. This will stop inaccurate readings occurring
from the LED sensor detecting normal light and indoor lighting.
installation
batteries replacement
To Next Page
Need help?
General
