It is recommended to use the removable fin in deep water (e.g. a lake or the sea)
where it allows you to move forward in a straight line. Do not use it in shallow water:
the fin would damage the bottom of the kayak in shallow water and reduce ma-
noeuvrability in white water. After the fin is installed, push through the locking pin. The
curvature of the fin must point towards the rear of the kayak.
The fin cannot be installed when the kayak is fully inflated.
Use the pump provided to fill each chamber, to meet the air pressure listed in the
specification. There are 3 valves to fill the floor and side chambers. Start with the side
chambers then inflate the floor chamber.
Unscrew the valve cap anticlockwise from the valve insert.
Insert the end piece of the pump hose, twist clockwise to lock into in place. Pump it
up until you reach the required pressure (refer to the Specification Table).
After inflation, tighten the valve caps clockwise so that no air escapes. To release the
air from the side tubes, unscrew the valve insert from the valve base in an anticlock-
wise direction.
To Next Page
Loading...