English
Specifications
• Active subwoofer
• Built-in class-D amplifier with adjustable active filters
• 200mm (8“) alumin cone woofer and 2x alumin cone passive radiators
• Controls for LEVEL, PHASE 0-180° and cutoff FREQUENCY 40-180 Hz
• Bass Boost 43 Hz +5 dB
• Power selector for manual or automatic operation ON-AUTO-STANDBY
• Power mode selector, controls and mains switch on the device backpanel
• AUDIO SIGNAL SENSOR for AUTO-ON and AUTO-STANDBY dependant from audio signal
• Line inputs with RCA sockets, ca. 600mV
• Connection through audio cable
• Frequency range: 30 - 180 Hz
• Amplifier output power (RMS): 125 W
• Mains voltages: 230/115 Volt ~ 50/60 Hz, standby consumption <0.5 W (230V)
• Dimensions (WxHxD): 260 x 260 x 260 mm
• System requirements: analogue audio source with RCA terminals
CE - Declaration of conformity
We herewith declare, that the wavemaster FUSION active subwoofer
complies with the following standards or normative documents:
EMC Directive (2014/30/EU)
EN 55032:2015, EN 55020:2017 + A12:2016,
EN 61000-3-2:2014, EN 61000-3-3:2013
LVD Directive (2014/35/EU)
EN 60065: 2014 + A11:2017
This statement is based on the test reports of an EMV - laboratory.
All texts and illustrations were produced with greatest care. wavemaster cannot however accept
any legal or other responsibility for any remaining incorrect information and its consequences.
Subject to change without further notice.
In case there is audible noise, possibly caused by strong radio waves (e.g. by mobile
phones) we recommend to turn down the volume control of the unit.
If you have special questions to the product and cannot find a solution in this introduction, you can
look for more informations at our homepage. Thank you!
www. wavemaster .eu
13
1-01
$-
!"#!$
(&)$$$
1%0
$+10
-20-
0
To Next Page
Loading...