9 10
WAVERUNNER MK3
USER MANUAL MK3
Trimming the motor
Differing loads, foreign bodies in the propellers plus wind and
water conditions mean that any bait boat will not always drive
straight. Use the motor trim roller on the upper-left of the
remote control handset to adjust (‘trim’) the motors so your
boat drives straight when the right hand joystick is in the
forward (12 oclock) position
1 Adjust the motor trim roller anti clockwise and the boat will
steer left.
2 Turn the motor trim roller clockwise and the boat will steer
right.
Turning the lights on and off
3 Turn the lights on and off with the top right ON/OFF switch.
Please note that the two front lights will only work when the
boat is driving forward.
On returning to the bank
1 Do not stop or pick up the boat by the aerial, as damage will
occur.
2 Switch off the boat first and then the handset.
Notes
• Always turn the handset on first and then the boat. To turn
off, turn off the boat first and then the handset. This will
ensure that you are always in control of the boat.
• The handset should be protected from water at all times.
• Continued starting, stopping and reversing of the boat drains
the battery. Smooth operation at all times is recommended
to ensure optimum battery life.
- Pushing the right (steering and speed) joystick quickly to
its extremes will put more stress on the electrical
components and the battery.
- Decreasing your speed slightly (your boat will still be very
quick!) will improve battery life.
Using your
Waverunner Mk3
Loading and dropping your bait
The left hand joystick operates the bait hopper doors.
1 Insert your rig into a hopper, if desired, by passing it under
the boat and up through your chosen hopper.
2 Close the hopper doors manually from below, ensuring ‘click’
closure.
3 Load either or both bait hoppers with your chosen bait.
4 Navigate your boat to your chosen spot
5 Move the left hand joystick to the left to open the left bait
hopper door. The port (left) navigation light will flash
simultaneously to confirm the release of your bait.
6 Move the left hand joystick to the right will drop the right
bait hopper door. The starboard (right) navigation light will
flash simultaneously to confirm the release of your bait.
Loading and releasing your rig
The left hand joystick operates the hook (rig) release system.
1 Insert your line(s), rigs or hooks on either or both of the
hook release sytem pins situated on the back of the boat.
2 Moving the left hand joystick up will drop the left rigs. The
port navigation light will flash simultaneously.
3 Moving the left hand joystick down will drop the right rigs.
The starboard navigation light will flash simultaneously.
To Next Page
Loading...