To Next PageTo Next Page
Need help?Do you have a question about the Weed Eater WT3100 and is the answer not in the manual?
General| Engine Type | 2-Cycle |
|---|---|
| Cutting Width | 16 inches |
| Type | Gas Trimmer |
| Line Diameter | 0.095 inches |
| Starting System | Pull Cord |
| Shaft Type | Straight |
| Handle Type | Loop |
Read and follow all safety rules and operating instructions to reduce risk of fire and serious injury.
Ensures operator safety by following guidelines on attire, alertness, hearing protection, and proper unit use.
Guidelines for safe operation and maintenance, including disconnecting spark plug and inspecting parts.
Safety measures for mixing, pouring, and storing fuel outdoors, away from sparks and flames.
Safe practices for cutting with the trimmer and precautions for transporting and storing the unit securely.
Step-by-step instructions for assembling the handle, ensuring proper alignment and secure fastening.
Familiarize yourself with the location and function of controls like the ON/OFF switch, primer bulb, and choke lever.
Details on how to use the ON/OFF switch to stop the engine.
Explains the function of the primer bulb in removing air and filling the carburetor for easier starting.
Guides the use of the choke lever for cold starting, warm starting, and stopping the engine.
Detailed steps for starting a cold or warm engine, including primer bulb and choke lever usage.
Procedure for starting a warm engine, involving the correct choke lever position and throttle control.
Guidance on how to start an engine that may be flooded with excess fuel.
Ensures safe operation by maintaining correct hand placement and body posture during use.
Inspect for loose/damaged parts, clean the unit, and clean the air intake screen before and after use.
Procedure for cleaning the air filter to maintain engine performance and reduce emissions, including oiling the filter.
Instructions on replacing the spark plug annually for easier starting and better engine performance.
Guide on how to replace worn cutting line, specifying the correct line diameter and installation method.
Procedure for adjusting the carburetor for idle speed, ensuring the trimmer head does not spin at idle.
Adjusting the engine's idle speed to prevent the trimmer head from spinning or the engine from stalling.
Steps for preparing the unit for seasonal storage, including cleaning and fuel system preparation.
Guidance on managing the fuel system for storage, including fuel stabilizer use and preventing gum deposits.
Specific procedures for storing the engine, including spark plug oiling and replacement.
Additional advice for storage, such as not storing old gasoline and replacing aging fuel cans.
