Need help?Do you have a question about the Weierwei VEV-V8 and is the answer not in the manual?
Lists all items included with the transceiver.
Instructions for attaching and detaching the battery pack.
Important safety guidelines for using the Li-ion battery pack.
Step-by-step guide for charging the battery pack.
How to attach and detach the transceiver antenna.
Instructions for attaching the belt clip to the transceiver.
Guide for connecting an earphone to the transceiver.
Steps to attach the hand strap for carrying.
Identifies and describes the physical parts of the transceiver.
Explains the function of each key on the transceiver keypad.
Introduces different operating modes like VFO and Memory.
How to navigate and use the transceiver's menu system.
Explains the indicators shown on the transceiver's LCD screen.
Steps to power the transceiver on and off.
How to control the audio output level.
Guide to setting the squelch to mute background noise.
How to select operating frequencies in VFO mode.
Instructions on how to send transmissions.
How to choose between high, mid, and low power output.
How to turn the FM radio feature on and off.
Guide to saving FM radio frequencies into memory.
How to access stored FM radio channels.
Steps to enter and navigate the menu system.
Details of various menu items and their settings.
Visual guide for setting up repeater communication.
Setting the frequency offset for duplex communication.
Defining the amount of frequency offset for duplex.
How to select and use CTCSS/DCS tones and codes.
How to choose specific CTCSS/DCS frequencies.
Reference table for standard CTCSS tone frequencies.
Reference table for standard DCS codes.
Steps to save frequency and data into memory.
How to retrieve stored memory channels.
Procedure to erase memory channels.
How to assign names to memory channels.
Toggling between memory name and number display.
Setting the display to show only memory channel numbers.
Resets transceiver settings, potentially clearing memory.
Resets settings except memory channels and lockout.
Resets all settings, including memory channels.
How scanning resumes after detecting a signal.
Scanning resumes after a set delay, regardless of signal.
Scanning resumes only after the signal drops out.
Steps to choose between Time-Operated and Carrier-Operated modes.
Scanning through all frequencies in the band.
Scanning through all programmed memory channels.
Preventing specific memory channels from being scanned.
To Next Page
General