weinor BiEasy 15M - Programming the Intermediate Position in; The Receiver; Programming the Ventilation;Tilting Position in the Receiver

36 | EN Ⓒ weinor GmbH & Co. KG
Ⓒ weinor GmbH & Co. KG EN | 37
Approaching the lower end position (roller shutter/awning)
Press the DOWN key briefl y. The blind approaches the
lower end position or the awning opens completely.
Approaching the lower end position (venetian blind)
Press the DOWN key until the status display lights up
briefl y. The blind approaches the lower end position.
Press the DOWN key briefl y (jogging mode with drive YES,
pulse operation with Combio Pulse). The blind moves briefl y
and then stops.
Approaching the upper end position (roller shutter /
awning)
Press the OPEN key briefl y. The blind approaches the
upper end position or the awning closes.
Approaching the upper end position (venetian blind)
Press the OPEN key until the status display lights up briefl y.
The blind approaches the upper end position.
Press the OPEN key briefl y (jogging mode with drive JA,
pulse operation with Combio Pulse), the blind moves briefl y
and then stops.
Intermediate position of blinds
Roller
shutter
Awning Venetian
blinds
Interior
shading
Pos
▼
Inter-
mediate
position
Intermediate
position
Intermediate
position
Inter-
mediate
position 1
Pos
▼
Ventilation
position
Fabric
tensioning
Tilting
position
Inter-
mediate
position 2
Tab. 11 Intermediate positions of blinds
4.6.5 Programming the intermediate position in
the receiver
Requirement
The transmitter is now programmed.
The end positions of the drive have been set.
The blind/shutter is at its upper end position.
1. Traverse the blind to the desired position with the DOWN
key. Keep pressing the DOWN button.
2. Press the STOP key also. The blind will stop. The status
display lights up briefl y.
The intermediate position is programmed.
4.6.6 Programming the ventilation/tilting position in
the receiver
Requirement
The transmitter is now programmed.
The end positions of the drive have been set.
The blind/shutter is at its lower end position.
• Traverse the blind in the UP direction with the UP key
until the ventilation gaps open or the slat tilt position
is reached. Keep pressing the OPEN button while it is
moving. In addition press the STOP button. The blind will
stop. The status display lights up briefl y.
The ventilation/tilt position is programmed.
Approaching the intermediate position
Requirement
The transmitter is now programmed.
The blind/shutter is at its upper end position.
1. Press the DOWN button briefl y twice. The status display
lights up briefl y.