Instructions for Assembly
Item number 116519-0000 Subject to technical modifications
Version 4 23.04.2014 Page 37/47
Cassita II/Cassita II LED
8 Electrical connection
8.1 Safety notes
Electrical hazards
Electrical hazards occur when the electrical connections are not performed properly.
The awning may only be connected to an electricity supply if the specifications
provided on the tag attached to the awning and/or the specifications provided in the
supplied assembly instructions tally with the power source. At the very least, the tag
and/or specifications must specify the voltage, frequency and output values.
A permanent electrical connection may only be made to power grids fitted with an all-
pole disconnector with a minimum 3 mm wide contact gap.
The installation instructions accompanying the supplied electrical components must
be observed.
8.2 Setting the end positions
Damage to the product
Incorrectly set end positions can result in the product being damaged.
Do not exceed the maximum permissible awning projection.
The centre joint may only be opened far enough to ensure that the high-tech belt is no
longer visible.
DANGER
CAUTION
To Next Page
Loading...
