Instructions for Assembly
Item number 116519-0000 Subject to technical modifications
Version 4 23.04.2014 Page 42/47
Cassita II/Cassita II LED
11 Troubleshooting
Error Cause Remedy
Drive not running
No power
Drive incorrectly connected
Drive is too hot
Drive is defective
Pre-set control not
functioning
Authorised person only
Re-connect drive (authorised
personnel only)
Wait 10 to 15 min
Replace drive (authorised
personnel only)
Authorised person only
Unit does not retract
completely
Drive not set correctly
Foreign body blockage
Correct the drive settings (fitter)
Remove foreign bodies
Unit not straight Unit not correctly aligned Align drive (fitter)
Not enough fabric tension End stop position exceeded Correct gear drive or motor
settings (fitter)
Drop profile not horizontal
when awning is open
Unit not correctly aligned Adjust inclination of arms
Unit does not close across
its entire width
Fabric seam not straight
Fabric has stretched to differing
lengths
Line fabric
Creasing and wrinkling Restricted unit None
12 Handover
All directions for use and maintenance documents must be handed over to the user at the time
of instruction. Detailed instruction on the safe and proper operation of the awning must be given.
If this is not adhered to and the awning is operated incorrectly, damage to the awning or
accidents could result. The instructions must be kept by the customer and passed on to the new
owner if ownership of the awning passes to a third party.
After noting the on-site structural conditions and completing assembly, the installation firm is to
inform the user whether the wind resistance class given by the manufacturer was achieved after
installing the awning. If not, the installation firm must record the wind resistance class actually
achieved. Automatic controls must be set to this level. The customer must confirm to the fitter in
writing that the awning is the right model and has been assembled correctly, indicating the
assembly time, and that final acceptance of the awning has taken place, during which the safety
notes were discussed (handover certificate).
To Next Page
Loading...
