weinor PergoTex II - Installation of the Safety Shield Retaining Profile Cover

PergoTex II/ PergoTex II LED
Instructions for assembly
Version 9
05.10.2017
We reserve the right to make technical changes
Item number
118697-0000
Page 48/66
6.4 Installation of the "safety shield retaining profile cover"
With a multi-section unit, the following profiles are delivered in two sections: "safety shield
retaining profile" and "wall connection upper part top section".
1.
Installation of the "safety shield
retaining profile cover"
• The surge point of the "safety shield
retaining profile" (1) and of the "wall
connection upper part top section" (2)
must be covered and sealed.
• To do this, the sealing tape (3) is
adhered to the bottom side of the
"safety shield retaining profile cover"
(4).
• Bolt with 2 drilling screws 3.9x13 Torx
(5).