weinor PergoTex II - Troubleshooting, Handover, and Compliance; 11 Fault Analysis

PergoTex II/ PergoTex II LED
Instructions for assembly
Version 9
05.10.2017
We reserve the right to make technical changes
Item number
118697-0000
Page 59/66
11 Fault analysis
Error
Cause
Remedy
Drive not running
• No power
• Drive incorrectly connected
• Drive is too hot
• Drive is defective
• Switch on power supply
voltage
• Re-connect drive (authorised
personnel only)
• Wait 10 to 15 min
• Replace drive (authorised
personnel only)
Construction switches off
with a delay and hums for
longer than 10 seconds
• Drive not set correctly
• Regulate the drive settings
(fitter)
Construction does not
retract or extend
completely
• Drive not set correctly
• Interim position adjusted
• Regulate the drive settings
(fitter)
• Erasing the interim position
Transoms do not travel
ascend evening during
extension/ slipping of
transoms
• Sleeve nuts over-tightened
at the suspension of the
transoms so that the
carriages are distorted
• Loosen sleeve nuts; extend
and retract the construction
several times. Carefully
tighten the sleeve nuts.
Popping sounds when the
construction is operated
• Toothed belt is not
adequately tensioned so that
it jumps on the belt pulley in
the end cap of the wall gap
sealing profile
• Open the end cap on the
side channel forwards and
retention the toothed belt
(torque for the screws 0.75
Nm)
Transoms not parallel to
guttering
• Side channels not correctly
aligned
• Fixation of top transom to
the fixed transom is not
correctly adjusted
• Align side channels
• Regulate anchorage for
transom
Water ingress at safety
shield
• Safety shield profiles not
adequately tensioned
• Tighten the bracing beneath
the safety shield
Clip profiles/ faceplates on
post are too loose and
rattle in the wind
• All clip connections are too
loose rather than too tight
due to component
tolerances
• Bend clip bars incrementally
until the clip connection is
tight
Beaded profile wall
bracket cannot be fitted
• Sideways screws over-
tightened on the beaded
profile leading to distortion of
the beaded profile
• Loosen the screws a little
sideways until the breaded
profile is straight
Clip profiles slide
downwards (gap in the
guttering)
• Clip profiles not cut evenly
• Underlay clip profiles
• Profiles bulge at the clip bars
Cover cap for transom
does not hold properly
• Transom is screwed on too
tightly (torque not adhered
to)
• Clip bar of cover cap for
transom is too loose
• Loosen hexagon cap nut
and tighten with the
prescribed torque
• Press the clip bar together
slightly