PergoTex II/ PergoTex II LED
Instructions for assembly
We reserve the right to make technical changes
12
Handover
All operation and maintenance instructions must be handed over to the user at the time of
instruction. Detailed instruction II on the safe and proper operation of the weinor PergoTex II
must be given. If this is not adhered to and the weinor PergoTex II is operated incorrectly,
damage or accidents could result. The instructions must be retained by the customer and
passed on to the new owner if ownership of the weinor PergoTex II is passed to a third party.
After noting the on-site structural conditions and completing assembly, the installation firm is to
inform the end-user whether the wind resistance class given by the manufacturer was achieved
after installing the awning. If not, the installation firm must record the wind resistance class
actually achieved. Automatic controls must be set to this level. The customer must confirm to the
fitter in writing that the weinor PergoTex II is the right model and has been installed correctly,
indicating the installation time, and that final acceptance of the weinor PergoTex II has taken
place during which the safety instructions were discussed.
13 Disposal
Although this product does not contain any materials which pose a risk or danger to the
environment. The weinor PergoTex II parts should nevertheless be disposed in the appropriate
To Next Page
Loading...
