WEISS GAMBIT DS1-MK3 - Page 28

OPERATING INSTRUCTIONS FOR GAMBIT DE-ESSER/COMPRESSOR DS1-MK3 TECHNICAL DATA
 Weiss Engineering Ltd., Florastr. 42, CH-8610 Uster Page 28
+41 44 940 20 06  +41 44 940 22 14  http://www.weiss.ch  weiss@weiss.ch
Remote
MIDI Implementation
System Inclusive
All band parameters plus the controls parameters are remote controllable. Each parameter has its corre-
sponding MIDI controller number.
According to the different parameters, the controllers are limited in their range. Invalid values are re-
placed by the maximum allowable value. Following is a list of the supported MIDI commands:
Action MIDI Mes-
sage
Status Byte Data Byte(s) Comment
Restore Snapshot Program Change 1100 cccc 0ppp pppp (cccc) Channel No.
(ppppppp) New Prog No: 0 - 127
Center Frequency 1 Control Change 1011 cccc 00000000 ($00) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0 – 105
Bandwidth 1 Control Change 1011 cccc 00000001($01) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0 - 48
Filter Mode 1 Control Change 1011 cccc 00000010 ($02) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0= limiter, 1= Bandpass,
2 = Lowpass, 3 = Hipass
Preview Delay 1 Control Change 1011 cccc 00000011 ($03) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0 - 32
Attack 1 Control Change 1011 cccc 00000100 ($04) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0 - 43
Release Delay 1 Control Change 1011 cccc 00000101 ($05) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0 - 53
Release Fast 1 Control Change 1011 cccc 00000110 ($06) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0 - 53
Average 1 Control Change 1011 cccc 00000111 ($07) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0 - 53
Release Slow 1 Control Change 1011 cccc 00001000 ($08) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0 - 53
Soft Knee 1 Control Change 1011 cccc 00001001 ($09) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0 - 10
Gain Makeup Mode 1 Control Change 1011 cccc 00001010 ($0A) (cccc) Channel No.
0vvv vvvv (vvvvvvv) New Value:
0= off, 1 = manual, 2= maximum