68 Chapter 5 Reviewing Patient Data Welch Allyn Vital Signs Monitor 300 Series
Replacing the Printer Paper Supply
To replace the printer paper supply, follow these steps.
1. Press to open the printer door.
2. Insert a new roll of paper.
3. Thread the end of the roll over the roller and through the slot in the printer door, as
shown.
4. With one hand, pull lightly on the paper to take up any slack. With the other hand,
close the printer door by pushing it down and into place until it clicks.
Note
Use only the thermal paper (part number 7052-25) supplied by Welch Allyn. The
use of any other paper can result in poor printer performance.
Note
The paper roll must be installed as shown in the illustration below. If the paper roll
is not installed correctly, the printer will not print.
Note
Be certain that the paper does not catch in the printer door.
To Next Page
Loading...
