Settings Default value
Authentication type WPA2-PSK
Authentication method Network key
Enable radio Enabled
Enable radio network alarms Disabled
Server
Obtain server IP information automatically Enabled
IP address 127.0.0.1¹
Port 281¹
UDP broadcast port 7711
¹ This default is available if Obtain server IP information automatically is not enabled.
Disassembly and repair reference
Screws
The following table lists torque specifications for all screws.
Qty Location Type Size/length Torque Bit type
1 Communications door Captive screw #8-32 X 0.656 6.0 in-lb ±1.0 in-lb #1 Phillips
8 Main board Pan head
machine
M3 X 8 6.0 in-lb ±1.0 in-lb #1 Phillips
4 Radio board
2 Battery connector board Plastite #4-20 X 0.500 7.5 in-lb ±0.5 in-lb Torx T10
4 Communications board
2 Ground stud assembly
4 Handle to front housing
6 Horizontal struts to front
housing
2 HSG clamp/temperature
housing
4 Metal chassis to bottom
housing
4 Power-supply cover
Service manual Appendices 117
To Next Page
Loading...
