Welch Allyn 6000 Series - Ethernet Messages; USB Messages

Message Possible cause Suggested action
Radio Software upgrade failed. The connection with the host was broken Re-establish the connection
and try again.
The radio was not provisioned correctly Reset radio to factory defaults
and try again.
Hardware error Replace the radio.
Information
Radio software upgrade in
progress. Do not shut down.
Radio software is being written to radio Do not interrupt the upgrade
until complete.
Radio card rebooting; please
wait.
The radio is restarting as part of the
software upgrade
Do not interrupt the upgrade
until complete.
Ethernet messages
Message Possible cause Suggested action
Alarm
Network not found; check
network cable connection.
A network cable is unplugged Check the network cable
connection.
A network connection is broken elsewhere Check network wiring.
USB messages
Message Possible cause Suggested action
Alarm
External device not recognized. An unrecognized external device is
connected
Reconfigure the external
device.
Replace the external device.
Disconnect the unsupported
device.
USB Communication failure.
Call for service.
An internal or external device is connected
but failed enumeration
Check external and internal
USB connections.
Check the external device.
USB Communication failure.
Call for service
An internal or external device is connected
but failed enumeration
Power down and restart the
monitor.
Check the external device.
Service manual Troubleshooting 43