Remove the power supply
1. Remove the rear housing as described in “Remove the rear housing.”
2. Remove the four Torx screws (10) securing the power-supply cover.
3. Remove the power supply cover (18).
4. Disconnect the following from the power supply:
• The (green) ground cable
• The AC power harness (17)
5. Remove the power supply.
Reassembly notes
• Ensure that the grommet on the AC power harness is in the slot in the power-supply cover.
• When replacing the power-supply cover, ensure that the antenna cable is routed in the
channel located at the top of the rear housing.
Service manual Disassembly and repair 57
To Next Page
Loading...
