Model options Cable positions Model options Cable positions
No SpO2 module
Install four USB cables
into the left five
positions of the USB
cable separator,
leaving the fifth
position open. Insert
the printer cable with
the retaining clip in the
second position from
the left.
No temperature
option
Install four USB cables
into the left five
positions of the USB
cable separator,
leaving the first
position open. Insert
the printer cable with
the retaining clip in the
second position from
the left.
No printer or SpO2
modules
Install three USB
cables into the left five
positions of the USB
cable separator,
leaving the second and
fourth positions open.
No printer, SpO2,
or temperature
option
Install two USB cables
into the left five
positions of the USB
cable separator,
leaving the first,
second, and third
positions open.
No printer, no
temperature
option
Install three USB
cables into the left five
positions of the USB
cable separator,
leaving the first and
second positions open.
• Space each cable about 1.5 inches from separator to the end.
• Place the separator in the unit in the approximate location shown here:
• Plug the USB cables into the main board connectors as follows:
Service manual Disassembly and repair 67
To Next Page
Loading...
