Remove the printer module
1. Remove the top housing as described in “Remove the top housing.”
2. Remove the two screws that secure the printer housing to the top housing.
3. Remove the printer from the top housing:
a. Hold the printer housing while opening the printer door.
b. Separate the printer and printer door from the top housing.
Reassembly notes
1. Place the printer door into the top housing assembly and hold it in place while performing the
next step.
2. Verify that the ground wire exits from the side opposite the printer board in the notched area.
3. Snap the printer door shut to hold the printer in place while securing it into the housing with
two screws.
When replacing the printer door
1. Remove the printer platen roller (68) from the existing door and secure it to the replacement
door with the two screws (72).
When replacing the printer module or adding a new option
• If adding a printer option, remove the printer blanking door. Remove any remaining gasket
material and clean the surface with 70 percent isopropyl alcohol.
1. Separate the door from the printer assembly.
2. Attach the printer ground harness to the printer ground lug.
Remove the light bar
1. Remove the top housing as described in “Remove the top housing.”
Service manual Disassembly and repair 69
To Next Page
Loading...
