Welch Allyn AED 10 - Detailed Operating Procedures

User Manual Using the Defibrillator 25
Operating Procedures – Detailed Information
The Quick Reference operating procedure in the preceding subsection provides the main
steps for operating the Welch Allyn AED 10:
1. Assess the Patient.
2. Attach the Electrodes and Connect the Cable.
3. Start the Welch Allyn AED 10.
4. Analyze the Patient’s Heart Rhythm.
5. Deliver the Shock (if prompted, press the red button).
6. Perform CPR.
For each step, detailed operating information or procedures follow.
Assess the Patient
Before using the Welch Allyn AED 10, assess the patient’s condition. Use the unit only if
all of the following patient signs are present:
• Unconsciousness
• Absence of breathing
• Unresponsiveness (no signs of circulation)
Attach the Electrode Pads and Connect the Cable
For defibrillation to be effective, it is important to correctly place the pads on the patient
and connect the electrodes to the Welch Allyn AED 10.
Before applying pads to the patient’s chest be sure to:
• Remove all clothing covering chest
• Wipe off any water, moisture, or perspiration
• Press the pads firmly to make sure they adhere securely to the chest.
To attach electrodes and connect the cable
1. Open the package containing the defibrillation pads and cable.
2. Peel off the backing from the electrode pad labeled RA. Place this pad just below the
patient’s right collarbone (sternum) as illustrated on the AED 10 pad placement
illustration.
Note
To remove pads, pull the wire upward from the device.
Note
DO NOT REUSE PADS.
WARNING Excessive body hair may affect the operation of the electrodes or
cause skin burns on the patient. Remove body hair as needed to ensure that the
electrode pads make proper contact with the patient's chest.