Note Be sure to support the LCD if you are removing it with the
frame. The foam strips on the LCD might cause the LCD to
stick to the frame.
4. Remove the LCD.
Reassembly notes
CAUTION The solder joint of the LCD connector (J48) is fragile. When
inserting or removing the flex cable, do not stress the solder joint.
Insert the LCD into the bezel in the front housing with the exposed board on the bottom.
Verify that the LCD flex cable feeds through the bezel’s clearance feature.
Place the LCD frame over the LCD. Verify that the LCD frame does not cover the LCD
flex cable.
When replacing the LCD
• Peel the protective sheet from the LCD.
• Verify that the foam strips are installed on the back of the LCD near the top and
bottom edges, and extend half way up from the bottom on both sides of the LCD.
Service manual Disassembly and repair 97
To Next Page
Loading...
