If you participate in a Partners in Care Biomed program, you can purchase an upgrade kit
and complete the installation on your own. Upgrade kits contain a Masimo module with
the desired parameters, a user interface license authorization code, and instructions for
installing and licensing the upgrade. To complete the installation, you also need the tools
listed in the “Disassembly and repair” section of this manual.
If you do not participate in a Partners in Care Biomed program, contact Welch Allyn to
order a Masimo hardware upgrade and arrange for Welch Allyn to perform the upgrade.
Customers performing hardware upgrades without participating in a Partners in Care
Biomed program void the device warranty.
Upgrading devices configured with Masimo SpO2
If your device has a Masimo SpO2 module, you can enable new parameters by
upgrading the module firmware. All customers can perform firmware upgrades on their
own by using the service tool. To upgrade your module, purchase a firmware upgrade kit
and follow the instructions provided with the kit.
Each parameter firmware upgrade is custom-built for a specific device and cannot be
transferred to another device.
Configure options
When connected and powered on, the monitor recognizes all options. When the option
successfully passes the POST, all software controls in the monitor’s user interface are
activated, enabling you to configure option settings.
Option parameters are initially set at factory default values. To change these settings go
to Advanced Settings. The configuration screens for NIBP, SpO2, SpHb, RRa, and
temperature are on the Parameters tab. The configuration screens for the radio are on
the Network tab. For more information about the Advanced Settings menu, see the
device’s directions for use.
Service manual Options, upgrades, and licenses 123
To Next Page
Loading...
