Welch Allyn Connex Spot Monitor - Reassembly Notes; Remove the Power Switch

Remove the power switch
1. Turn over the front housing.
2. Peel off the power switch button from the front housing (it is very sticky).
3. Unthread the power switch flex through the front housing.
Reassembly notes
Kit item:
• 105944, Power switch
Note Reassembly is not the reverse of disassembly.
When replacing the power switch
1. First complete the following steps:
• Remove the rear housing.
• Separate the main PCA board from the front housing.
• Disassemble the front housing.
• Attach the power switch.
76
Disassembly and repair Connex
®
Spot Monitor