Welch Allyn Connex VSM 6000 series - Office Profile

a. Touch the Settings tab.
The Monitor tab appears.
b. Touch End monitoring.
An "End monitoring" dialog appears with the following options:
• New patient – Clears patient and location context and review data after you
remove patient sensors
• Power down – Clears patient and location context and review data, and
powers down the device
• Cancel – Retains patient data and returns to Home tab
c. Touch New patient.
d. Complete step 1.
Note If patient context has been established and you attempt to
select a new patient by navigating to the List tab, the device
displays the message, "Patient already assigned to device.
To assign a different patient, end monitoring for the current
patient."
Office profile
The Office profile supports manual entry of patient information.
Some configurations also enable scanning of patient barcodes. These configurations,
specified in Advanced Settings, include the following:
•
The "Primary label" setting is Patient ID.
• The "Primary label" setting is Name and the "Search by patient ID" setting is selected.
Manually enter patient information
In the Office profile, you can manually enter patient information in the Patient frame.
1.
From the Home tab, touch the keyboard icon in the Patient frame.
The keyboard appears.
2. Enter patient information. Touch , if displayed, to cycle through the
patient data fields.
Note The "Primary label" setting in Advanced Settings specifies
available fields.
3. Touch OK.
The information appears in the Patient frame.
4. To change the patient type, touch the patient type button (located on the right side
of the Patient frame).
CAUTION Verify patient identity on the monitor after manual or barcode
entry and before printing or transferring patient records.
94 Patient data management Welch Allyn Connex
®
Devices