Integrated Wall System
CAUTION Welch Allyn is not responsible for the integrity of any wall
mounting interface. Welch Allyn recommends that you contact your
Biomedical Engineering Department or maintenance service to ensure
professional installation, safety, and reliability of any mounting accessory.
Supplies and accessories
For a list of all approved supplies and accessories, see Approved Accessories in the
Appendices.
Unpack the wall system
This procedure applies to first-time setup of the wall system.
CAUTION You must follow these instructions exactly to ensure safety and
ease of assembly.
CAUTION Do not remove any packing materials around the wall system
until the instructions tell you to do so.
1. Lift the wall system out of the box by the cardboard handles.
2. With the wall system still in its packing material, place it onto a table or flat work
surface and remove it from the plastic bag.
3. Turn the wall system over so that back of the wall system faces up.
Directions for use Setup 41
To Next Page
Loading...
