Patient data management
Patient demographic data is managed on the Patients tab.
From this tab, you can do the following:
• Retrieve a patient list from the network (for example, electronic medical records
(EMR) or a central station).
• Select a patient from the list.
• Manually create patient entries and a patient list.
• Scan a patient ID with the barcode scanner and return a patient name match from
your host system.
Note The patient name match could come from EMR or a central
station.
• Enter additional patient information such as manual parameters.
• Assign a patient and location to device only or to a central station during continuous
monitoring.
CAUTION Verify patient identity on the monitor after manual or barcode
entry and before printing or transferring patient records.
Add a patient to the patient list
Note If the monitor is configured to retrieve the patient list from the network and
is in the Spot Check or Intervals Monitoring profile, you cannot manually
add a patient to the patient list.
Note If the monitor is configured to retrieve the patient list from the central
station and is in the Continuous Monitoring profile, you can add a patient to
the patient list and transfer it to the central station.
1. Touch the Patients tab.
2. Touch Add.
3. Touch and then enter patient information. Touch Next to cycle through the
patient data fields.
Note You can use a barcode scanner to enter a patient ID in the
Patient ID field. Touch in the Patient ID field, scan
the barcode, and touch OK.
91
To Next Page
Loading...
