a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter 6345 as the Advanced settings code.
d. Touch OK.
The General tab appears on the bottom of the screen and the Regional tab appears
on the top of the screen.
2. Touch the Ownership tab.
3. Specify settings.
Setting Action/Description
Practice ID Use the keyboard to add the Practice identification.
Touch OK.
Contact information Use the keyboard to add the Contact information. Touch
OK.
Device ID Use the keyboard to add Device identification. Touch
OK.
4. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home screen, touch Exit.
Start Demo
Start the demo mode
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter 6345 as the Advanced settings code.
d. Touch OK.
The General tab appears on the bottom of the screen and the Regional tab appears
on the top of the screen.
2. Touch the Demo tab.
3. Touch Demo to put the CP150 in demonstration mode.
Once the demonstration mode is complete, the device returns to the Home screen.
Network
View advanced CP150 information
The Advanced Settings screen shows the CP150's software version, battery charge
state, Ethernet and wireless radio MAC and IP addresses, network, server and access
point information, session information, and more.
View Radio and Ethernet status
Note
This task is applicable only to devices that have a radio installed and an
activated license.
30 Settings CP 150 12-lead resting electrocardiograph
To Next Page
Loading...
