Welch Allyn LS-135 - Page 13

4. Install the new Lamp
• Verify that the lamp number located on the metal plate inside the
Light Assembly ® (photo #2) matches the replacement lamp
number.
• Replace Lamp © and reattach Lamp Retaining Wire ® to Lamp
Housing ®.
• Align Lamp pins to Lamp Socket holes and reconnect Lamp
Socket.
• Reinstall Lamp Housing ® onto Light Assembly ® by first
engaging Lamp Housing tab (opposite screw) into Light
Assembly. Fully tighten screw.
• Reconnect Power cord and verify Lamp operation.
#1 #3
©
9