Welch Allyn LS-135 - Disassembly Instructions

DISASSEMBLY INSTRUCTIONS
If returning a floor stand unit for service, disassemble the flexible arm
from the pole to prevent damage.
1. Turn the power switch to the OFF position ( a ) and unplug the
cord from the outlet.
2. Using a small flat head screwdriver, CAREFULLY pull back the
tabs at the top of the pole slightly - just enough to disengage
them from the black plastic insert in the pole.
3. Pull up on the bottom end of the flexible arm. Unplug the
electrical connector and remove Luminaire-Flexible Arm
assembly from the pole.
4. Tilt the pole/base onto its side and unscrew the large phillips
head screw located on the bottom center of the base.
5. Remove the metal base cover plate and disconnect the
connector attached to it.
6. Disconnect the remaining electrical connector from the base and
pull the pole out of the base.
7 Securely wrap the three components (base, pole, and Luminaire
assembly) and loose parts in suitable protective packaging) for
shipment to your authorized service center.
NOTE: This product contains no materials classified as hazardous.
Therefore, its disposal is not deemed as harmful to the the environment
or health risk to individuals disposing of the product. As a precaution, it is
recommended you contact your local disposal and/or recycling authority
for information regarding the disposal of the equipment.
14