Welch Allyn LS-135 - Page 9

6. From the parts kit, obtain the
screw and external lockwasher and
install through the plate, place the
plate into the base, threading
screw clockwise into pole. Tighten
firmly, using screwdriver. Refer to
photo 6.
7 With the base/pole still lying on its
side, gently pull the electrical
connector from inside of the pole
using the twist tie. Remove and
discard twist tie. Refer to photo 7
Orient the Luminaire-flexible arm
assembly's electrical connector to
the remaining pole electrical
connector and connect each by
firmly pressing together. Refer to
photo 8.