If you select the Step algorithm, touch and
enter a default cuff inflation target for each type of
patient. In the Patients tab on the Summary tab,
clinicians can change the CITs from the default
CITs that you set here.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify advanced temperature settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab will appear.
2. Touch the Parameters tab.
3. Touch the Temperature tab.
4. Specify settings.
Setting Action/Description
Unit of measure Select primary units of measure for the
temperature display on the Home tab
Display temperature conversion Select this to display primary units of measure and
secondary units of measure for the temperature
display on the Home tab.
Default SureTemp Plus site Select the default site for SureTemp
measurements. The default site applies when
clinicians power up the monitor and each time
clinicians remove the temperature probe from the
well.
Select Last Site to set the default to the site
selected for the last measurement.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify advanced SpO2 settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
114
Advanced settings Welch Allyn Vital Signs Monitor 6000 Series™
To Next Page
Loading...
