a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Data Management tab.
3. Touch the Clinical Data tab.
4. Specify settings.
Setting Action/Description
Automatically send on manual save Select this option to specify that measurements are
sent to the network when a clinician saves
measurements on the Home tab.
Delete readings after successful send Select this option to specify that measurements are
deleted from the monitor after they are successfully
sent to the network. Sent measurements do not
appear in the Review tab.
Emulate Spot Vital Signs LXi Select this option to specify that clinical data sent
to the network appears as Spot Vital Signs LXi data
at the network.
5. Do one of the following:
• To continue in Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Network
View advanced monitor information
The Status tab shows the monitor's software version, MAC and IP addresses, network, server and
access point information, session information, and more.
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Network tab.
3. Touch the Status tab.
4. View the information.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify radio settings
This task is applicable only to monitors that have a radio installed.
118
Advanced settings Welch Allyn Vital Signs Monitor 6000 Series™
To Next Page
Loading...
