1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Network tab.
3. Touch the Radio tab.
4. Specify settings.
Setting Action/Description
SSID Touch and enter the service set identifier
(SSID). Enter a maximum of 16 characters.
Radio band Select the radio band.
Authentication type Select an authentication scheme.
Method Select a method. Then touch and enter
characters: Network key (maximum of 64
characters), or Passphrase (maximum of 63
characters).
Enable radio Select to enable radio for device communications.
When disabled, the radio is not available.
Enable radio network alarms Select to activate radio network alarms when an
alarm condition occurs. When disabled, radio
network alarms are not available.
Configure radio Touch Configure radio to activate all new
radio settings not selected previously.
Touch OK in the confirmation popup telling you to
power down the monitor.
Touch the Settings tab. Touch the Device tab.
Touch Power down.
The radio will reboot.
Note If you do not touch Configure radio,
none of the changed radio settings will take effect.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify server settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
Directions for use Advanced settings 119
To Next Page
Loading...
