Battery power manager messages
Message Possible cause Suggested action
Low battery 5 minutes or less
remaining. (High-priority alarm)
Battery power is extremely low Connect the monitor to AC
power. (If not connected to
AC power, the monitor powers
down when AC power is
depleted.)
Low battery 30 minutes or less
remaining.
Battery power is low
Touch OK to dismiss or
connect the monitor to AC
power.
Powering down. Call for
service.
Power manager or battery faults have
occurred
Call for service.
Battery is absent or faulty. There is no battery in the monitor Insert a battery.
The battery is faulty Replace the battery.
Device is operating in battery
mode.
The AC power cord has been disconnected
Touch OK to dismiss or
connect the monitor to AC
power.
Configuration Manager messages
Message Possible cause Suggested action
Unable to load configuration;
using factory defaults.
A configuration load error occurred Call for service.
Functional error. Call for
service.
A critical configuration load error occurred Call for service.
No connection for send. The monitor is not configured to the network Call for service.
Printer messages
Message Possible cause Suggested action
Low battery; plug into outlet. The monitor's battery voltage is too low to
support printing
Connect the monitor to AC
power.
Printer door is open; close to
continue
The printer door is open Close the printer door.
Out of paper. The paper is not properly loaded Align the paper with the print
head. If the problem persists,
call for service.
The paper sensor does not detect paper Replace the paper. If the
problem persists, call for
service.
126
Troubleshooting Welch Allyn Vital Signs Monitor 6000 Series™
To Next Page
Loading...
