Welch Allyn VSM 6000 series - Detach an Accessory; Insert a New Roll of Paper

Caution Connect cables in a manner that minimizes entangling.
3. Close the door and tighten the screw.
Detach an accessory
1. On the rear of the monitor, loosen the screw on the USB door and open it.
2. Detach the accessory's USB cable from USB port on the monitor.
3. Close the door and tighten the screw.
Insert a new roll of paper
The printer is located on the top of the monitor. Follow these steps to insert the roll of printer paper:
1. Grasp the two tabs and pull up to open the printer door.
2. Insert a new roll of paper.
Note The paper roll must be installed as illustrated. If the paper roll is not
installed correctly, the printer will not print properly.
3. Advance the end of the roll past the roller so that it extends past the printer door, as shown.
22
Setup Welch Allyn Vital Signs Monitor 6000 Series™