4
7), unplug the power cord to stop the machine, turn the mixing cup counterclockwise by about 30
degrees, and then remove the cup (see figure 8) Pour the contents of the cup into the prepared utensil.
(Figure 9/10)
8. Do not spray water or other liquids during use.
◆ Cleaning method
1. Add the right amount of warm water and a small amount of
food detergent when cleaning the mixing cup, cover the cup
cover and turn the switch knob “P” to run for about 10 seconds
(see Figure 11); you can also immerse the mixing cup in water
Brush cleaning.
2. After stirring, turn the switch knob to the "0" position,
unplug the power cord and remove the mixing cup from the
host (see Figure 12), then remove the cup cover assembly and
pour out the water. Use a dry cloth or towel Dry the blender.
(Note: the mixing knife in the cup is very sharp, be careful to
hurt your hands)
3. The main body should be wiped clean with a damp cloth. Do
not rinse with water to avoid damaging the machine..
Waste electrical and electronic equipment are a special waste category, collection,
storage, transport, treatment and recycling are important because they can avoid
environmental pollution and are harmful to health. Submitting waste electrical and
electronic equipment to special collection centers makes the waste to be recycled
properly and protecting the environment. Do not forget! Each electric appliance that
arrives at the landfill, the field, pollutes the environment!
Importer & distributor:
SC VITACOM ELECTRONICS SRL
CIF: RO 214527
Tel. 0264-438401*
sales@vitacom.ro, www.vitacom.ro
To Previous Page
Loading...