Direction For Use
1. Place the battery correctly and close the battery cover, and set the switch to AUTO, the it goes
into light control+ human body induction mode (set the switch to ON or Always mode, to OFF for
Shutdown mode).
2. When it gets dark around, once person or animal enters the sensing area, its light will be on for
about 30 seconds.
Sensing Range
It can sense darkness through photodiode and sense the activities from human and animal (heat) through
the body infrared sensor within the range showed in the picture below to tigger the auto-light on.
The above measurements are measured at a temperature of 25
o
C. The sensing range of infrared sensors
varies slightly according to temperatures.
To Next Page
Loading...