Need help?Do you have a question about the Wera 8002 C Koloss 1/2 and is the answer not in the manual?
Attach the socket to the push-through square drive until the ball lock engages.
Features 60-tooth pitch and 6° return angle for easy use in tight spaces.
Remove socket, push drive through, replace socket to switch rotation direction.
Utilize the two flat striking faces to drive bolts out of their holes or align components.
The rubber pad protects surfaces and components during hammering.
Align the extension at a 90° angle and insert it to lock.
Turn extension by 90°, release locking pin to detach.
Caution: Maximum torque with extension must not exceed 600 Nm.
Insert and secure the centring pin into the handle for aligning holes or lugs.
Use for intended purposes, ensure secure connections, and avoid sharp corners.
Avoid hardened parts, use defined zones, protect surfaces, and check for damage.
Adhere to 600 Nm torque limit, stop if tool bends, and return for repair if warning line appears.
General| Brand | Wera |
|---|---|
| Model | 8002 C Koloss 1/2 |
| Category | Power Tool |
| Language | English |
To Next Page
